Dodge Rampage P0743 Engine Error Code
When you check Dodge Rampage car engine light came on code P0743 the reason should be Engine Light ON (or Service Engine Soon Warning Light). However Dodge manufacturer may have a different definition for the P0743 OBD-II Diagnostic Powertrain (P) Trouble Code. So you should chech it on our car models.
Another consequence of P0743 Dodge Rampage engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
Dodge Rampage P0743 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionDodge Rampage car P0743 OBD-II Trouble Code The Torque Converter Clutch (TCC) solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control MReason For Dodge Rampage P0743 CodeThe reason of Dodge Rampage P0743 OBD-II Engine Error Code is P0743 Torque Converter Clutch Circuit Electrical. |
If your P0743 Dodge Rampage check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system and engine control unit are in charge of monitoring a bunch of different P0743 Dodge Rampage, and if they get a reading that's a little out of whack, up pops the check engine light.
Dodge Rampage P0743 Possible Solution :
Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.
What does fault code P0743 mean for Dodge Rampage ?
|